CYBEX 530S Owner's Manual page 48

! WARNING: Always use proper lifting methods
when moving heavy items.
4. Lift and move the unit
A. Lift and move or roll the unit using the front
transport wheels to the location where you
intend to leave it. Use proper lifting methods.
5. Attach the Display Upright to Base Assembly.
NOTE: If attaching the A/V option, refer to the 530S
A/V bracket installation instructions (supplied
with the A/V bracket).
A. Locate the display upright (#2), four screws
5/16-18 X .75" (#14) and four washers 5/16"
(#18). See Figure 3.
B. Attach the display cable from the bottom of
the display upright (#2) to the end of the
display cable on the base frame (#1). Make
sure the cable connector latches snap into
place. See Figure 4.
C. Using a 1/2" open end wrench secure the
display upright (#2) to the base (#1) using four
screws 5/16-18 x .75" (#14) and four washers
5/16" (#18). See Figure 3.
D. Locate the wire tie (#21) and secure the
display cable to the upright (#2). See Figure 3.
6. Attach the Display Upright Collar.
A. Locate the display upright collar (#3) and four
screws 10-24 x 3/4" (#18).
B. Slide the display upright collar (#3) down over
the display upright (#2) and attach to the base
(#1) using four screws 10-24 x 3/4" (#17), as
shown in Figure 5.
Setup
and Assembly
Page 5-6
Cybex 530S Owner's Manual
#21
Figure 3
Figure 4
#2
#15
#18
#18
#1
Display
Cable
#15