Stopping The 530S Stepper; Control During Operation - CYBEX 530S Owner's Manual

7. When you complete a program the unit begins a countdown, "3...2...1" and sounds a tone for
each count and ends with a long tone. Workout Review displays for 20 seconds (default setting) or
until you press the Pause/end key.
! WARNING: Wait until pedals come to a complete stop before dismounting.
8. Wait until pedals come to a complete stop before dismounting the unit. Hold the handrails to
steady yourself while you step off the unit.
9. The unit returns to Dormant Mode.
Stopping The Cybex 530S Stepper
Press Pause/end once to pause your workout for 20 seconds (default setting) and to enter the Workout
Review. As you stop stepping and come to a complete stop all workout settings and data will remain in
memory for the pre-selected time. Press the Quick Start key within the default setting to continue your
workout. If the Quick Start key has not been pressed during the 20 second pause, workout data will
be cleared and the display will return to Dormant Mode.
Press Pause/end a second time to interrupt workout data from cycling and to change the display to
Dormant Mode.
! WARNING: Wait until pedals come to a complete stop before dismounting.
Emergency Dismount: Follow the steps listed below if you experience pain, feel faint or need to stop
your unit in an emergency situation:
1. Grip handrails for support.
2. Stop stepping.
3. Continue holding the handrails while you step off the unit.

Control During Operation

Control keys on the display are usable during operation and may be pressed at any time to make
adjustments in speed or data readouts.
Changing Level - Press the Level + - keys to change the speed in increments of 5. Minimum to
maximum speed is from 10-150 feet per minute.
Changing Programs - When changing programs, your data from the previous program will transfer
when changing from a program to Manual Mode or Manual Mode to a program.
Changing Workout Time - Press Time to alter the amount of time you plan to workout. You can
change Time before or during a workout. NOTE: The Max default time may limit your time. See Setting
Operation Options in Chapter 5.
Changing Data Readouts - Press Scan once to continue to display a set of data. Press Scan again
and it will continually review each set of data. NOTE: The automatic scan is a feature that can be
toggled and/or turned on or off. See Setting Operation Options in Chapter 5.
Cybex 530S Owner's Manual
Operation
Page 3-5