Dimplex DF2690 Service Manual page 4

1. Ensure that power is supplied through main service
panel.
2. Locate manual controls. (FIGURE 1)
3. Activate main power switch.
4. Press and hold the Manual Selection Switch in the
" I " position for 5-10 seconds. (The second red
indicator light will flash). (FIGURE 3)
5. Press the ON button located on the remote control
transmitter.
This will synchronize the remote control transmitter and
receiver.
Remote Control Usage
The remote control operates the fireplace levels
sequentially. The level is increased every time the "ON"
button on the transmitter is pressed. The fireplace can be
turned off at any point by pressing the "OFF" button on the
remote control transmitter.
Level 1: The flame effect is turned on and the first red
indicator light is activated.
Level 2: The flame effect remains on, the heater is
activated to the low heat setting, and the first and
second red indicator lights remain activated.
Level 3: The flame effect remains on, the heater is set to
the high heat setting, and all three red indicator lights
are activated.
Battery Replacement (FIGURE 4)
To replace battery:
1. Slide battery cover open on the hand held transmitter.
2. Install one 12-volt (A23) battery in the battery holder.
3. Close the battery cover.
FIGURE 4
2
Battery
Battery
Cover