Operating Tips - Yard-Man Style L Operator's Manual

• To readjust the control cable, loosen the hex jam
nut on the auger control cable "Z" fitting.
• Rotate the coupling end of the cable
counterclockwise to provide more slack.
• Retighten the hex jam nut. See Figure 1.
• Repeat Auger Control Test to verify proper
adjustment has been achieved.
Figure 1
Chute Clean-Out Tool
The chute clean-out tool is conveniently fastened to the
rear of the auger housing with a mounting clip. Should
snow and ice become lodged in the chute assembly
during operation, proceed as follows to safely clean the
chute assembly and chute opening:
• Release both the Auger Control and the Drive
Control
.
• Stop the engine by removing the ignition key.
• Remove the clean-out tool from the clip which
secures it to the rear of the auger housing.
• Use the shovel-shaped end of the clean-out tool to
dislodge and scoop any snow and ice which has
formed in and near the chute assembly.
WARNING:
snow and ice from the chute assembly or
auger housing
• Refasten the clean-out tool to the mounting clip on
the rear of the auger housing, reinsert the ignition
key and start the snow thrower's engine.
• While standing in the operator's position (behind
the snow thrower), engage the auger control for a
few seconds to clear any remaining snow and ice
from the chute assembly.

Operating Tips

NOTE:
Allow the engine to warm up for a few minutes
after starting. The engine will not develop full power
until it reaches operating temperature.
WARNING:
surrounding areas become hot and can
cause a burn. Do not touch.
• Discharge snow downwind whenever possible.
• Slightly overlap each previous swath.
• Set the skid shoes 1/4" below the scraper bar for
normal usage. The skid shoes may be adjusted
upward for hard-packed snow. Adjust downward
when using on gravel or crushed rock.
• Avoid possible starter freeze-up. Clean the snow
thrower thoroughly after each use.
12
Never use your hands to clean
The muffler, engine and