Using The Controls - Image IMHS63103 User Manual

Using the Controls

Air Controls 1, 2, and 3
A
Air Control 1: Determines the amount of air flowing
through the hydrotherapy jets labeled A (above). If the
control is turned counterclockwise, the amount of air
flowing through the jets will increase; if the control is
turned clockwise, the amount of air will decrease.
Air Control 2: Determines the amount of air flowing
through the hydrotherapy jets labeled B (above). If the
control is turned counterclockwise, the amount of air
flowing through the jets will increase; if the control is
turned clockwise, the amount of air will decrease.
Air Control 3: Determines the amount of air flowing
through the hydrotherapy jet labeled C (above). If the
control is turned counterclockwise, the amount of air
flowing through the jet will increase; if the control is
turned clockwise, the amount of air will decrease.
A
B
C
A
B
Display
Invert Button
Pump 1 Pump 2
Button Button
Display Invert Button: Turns the display 180°, allow-
ing it to be read from inside or outside of the spa.
Pump 1 Button: Turns the spa jets labeled B and C
(at the left) on and off. If the button is pressed once,
the jets will run, providing gentle hydrotherapy. If the
button is pressed again, the jets will shut off.
Pump 2 Button: Turns the spa jets labeled A (at the
left) on and off. If the button is pressed once, the jets
will run, providing soothing hydrotherapy. If the button
is pressed again, the jets will shut off.
The spa also features an automatic mode that heats
and filters the water when the spa is left unattended.
When the power to the spa is first turned on, or if the
water temperature is below the set temperature, the
water will be heated as required to maintain the set
temperature. Note: To keep the filter and heat
cycles from running, the power to the spa must be
turned off.
Light Button: Turns the underwater light on and off.
Temperature Buttons: Control the temperature setting
of the water. The temperature setting can be from
80°F to 104°F. The water heats at about 6°F per hour
with the cover on. Use a medical or other accurate
thermometer to check the temperature of the water.
Note: The word "COOL" will appear in the console
display if the temperature of the water is more than
20°F cooler than the set temperature. When this hap-
pens, the heater will automatically activate to warm the
water. The word "ICE" will appear in the display if the
temperature drops below 40°F. If this happens, the
pump will automatically circulate the water and warm
the plumbing to keep the water from freezing.
12
Display
Light Temperature
Button Buttons