Using The Whirlpool Function; Adjusting The Tub Height - 6302Gadh Only - Invacare 6302G User Manual

5 OPERATION
5.6

Using the Whirlpool Function

1. If the water level does not cover the whirlpool jets, push the tub fill button to auto-fill the tub.
2. After the water level covers the whirlpool jets and after bathing the resident, add Invacare Defoamer to the bath water. Refer to the Defoamer
bottle for directions.
3. Push the whirlpool button to start whirlpool jets.
4. After use, press the whirlpool button again to stop the whirlpool jets.
5. Drain the tub completely.
6. Use the stretcher lift to transfer the resident from the tub.
7. Clean and disinfect the tub. Refer to Cleaning and Disinfecting on page 23.
5.7

Adjusting the Tub Height - 6302GADH Only

WARNING
DO NOT stand on the tub frame. Keep feet away from
tub and frame, otherwise injury may occur.
CAUTION
DO NOT adjust the height more than three cycles (up
and down) within a ten minute period. Damage to the
actuator may result.

The tub stops automatically when the maximum
height adjustment UP or DOWN is reached.
Perform one of the following:
• Press and hold the UP button. Release the UP button when the
desired height is reached.
• Press and hold the DOWN button. Release the DOWN button
when the desired height is reached.
Invacare® Supine Whirlpool Tubs
UP Button
DOWN Button
28
Part No. 1167456