Securing The Tub; Leveling The Tub - Invacare 6302G User Manual

4 INSTALLATION
4.3

Securing the Tub

WARNINGS
Protective eye wear MUST be worn when drilling to
avoid possible eye injury.
DO NOT adjust height of legs more than 1 inch (25.4
mm) for Model 3652G or 2 inches (50.8 mm) for model
3602GXL; leg will disassemble from leg mounting pad
and serious injury may occur.
1. Set the tub in place.
2. Ensure the plumbing and electrical hook-ups have been installed.
3. Mark the locations of the anchor holes, using pre-drilled holes in leg
mounting pads as a template.
4. Move the tub away from the mounting area.
5. Drill anchor holes in floor. Use jack-drill and carbide bit in concrete
or a wood bit for wood floors.
6. Reposition the tub in the mounting area, aligning the holes in the leg
mounting pads with the holes drilled in STEP 4.
4.4

Leveling the Tub

1. Level the tub by adjusting the telescopic legs either up or down,
using a wrench, to arrive at the desired height.
2. Check to make sure the tub is level by placing a level on the front
and sides of the tub.
3. Repeat STEPS 1 and 2 until the tub is level.
4. Secure the legs to the floor using fasteners appropriate to the floor
material and in keeping with local codes.
Invacare® Supine Whirlpool Tubs
SECURING LEGS TO FLOOR
Leg
Lag Bolt
LEVELING SIDE TO SIDE
Level
LEVELING END TO END
Level
16
Leg Mounting Pad
Lag Bolt
Anchors
Part No. 1167456