Label Length; Label Width; Line Analyzer; Log To Card - Intermec PF2 4i User Manual

Label Length

Purpose:

Label Width

Purpose:
Default:

Line Analyzer

Purpose:
Default:

Log to Card

Purpose:
Default:

LTS

Purpose:
Default:

Media Contrast

Purpose:

Specifies the length of the labels in [inches] or [mm]
depending on the units selected. This parameter
is automatically set during the Initial Setup
Configuration process.
Note: You can only set the label length if the Media
Type is set to Continuous.
Specifies the width of the label in [mm] or [inches].
You should set the width to prevent labels from being
printed outside of the printable area, which may harm
the printhead.
Full width of printhead:
EasyCoder PF2i:
EasyCoder PF4i & PM4i:
EasyCoder PX4i:
EasyCoder PX6i:
EasyCoder PD41:
Determines whether to print received data on the
label.
Off
Logs the received data to a file on a CompactFlash
card. You can use the log file for later analysis.
Off
Turns the label taken sensor (LTS) on or off.
Off
Adjusts the darkness and contrast of the printout.
You can adjust this value from 0 to 30. Has influence
only on the Fingerprint setup parameter "contrast."
A value of 15 corresponds to the Fingerprint contrast
value 0%.
56 mm (2.2 inches)
104 mm (4.1 inches)
112 mm (4.5 inches)
166 mm (6.6 inches)
104 mm (4.1 inches)
ZSim v5.XX User's Guide