Troubleshooting Guide; Fcc Information - Spektrum DX3C Instruction Manual

TROUBLESHOOTING GUIDE

Problem
The system will Transmitter and receiver too near each other
not connect
Transmitter and receiver too near large metal
Selected model is not bound in transmitter
Transmitter accidentally put in bind mode so
receiver is no longer bound
The receiver goes Check the receiver antenna to be sure it is not
into failsafe mode a cut or damaged
short distance away
from the transmitter
Receiver quits Low battery voltage
responding during
Loose or damaged wires or connectors between
operation
battery and receiver
Receiver loses its Transmitter accidentally put in bind mode, ending
bind bind to receiver
Receiver taking Transmitter and receiver are operating on Marine
longer than usual to model
link with transmitter

FCC INFORMATION

any interference received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly
approved by the party responsible for compliance could
This product contains a radio transmitter with wireless technol-
ogy which has been tested and found to be compliant with
the applicable regulations governing a radio transmitter in the
Possible Cause
Antenna Separation Distance
When operating your Spektrum transmitter, please be sure to
antenna to meet RF exposure safety requirements as determined
by FCC regulations.
area and typical hand placement when operating your Spektrum
transmitter.
Solution
receiver
Make sure correct model memory is selected and that
transmitter is bound to the model
Rebind transmitter and receiver
Replace or contact Horizon Product Support
Make sure receiver antenna is in an antenna tube and
is above vehicle
Completely recharge battery
Do a check of the wires and connection between
battery and receiver. Repair or replace wires and/or
connectors
Marine receivers can take longer to link with
transmitter
EN
15