How To Stick The Sheet (G11-4326-04); How To Attach The Tx-Rx Unit; How To Attach The Vgs-1 - Kenwood TK-2180 Service Manual

TK-2180

2. How to Stick the Sheet (G11-4326-04)

1) Remove the white separation paper of the sheet first (q)
and stick the sheet on the front-glass (w).
Next, remove the transparent separation paper of the
sheet (e).
e

3. How to Attach the TX-RX Unit

1) In order to attach the TX-RX unit in chassis, don't put in the
TX-RX unit aslant.
Please level the chassis and the TX-RX unit and attach
them.
6
DISASSEMBLY FOR REPAIR
Sheet (G11-4326-04)
q
Front-glass
w

4. How to Attach the VGS-1

1) Remove the 2 screws.
2) The tip of tweezers is put into the screw hole of the cover
and is pried, the cover will remove.
3) Use the 2 rubber cushions and attach them to the VGS-1.
4) Plug the VGS-1 into the VGS-1 connector of the PC board,
pressing down on the top of the VGS-1 until secure.
5) The spacer turns the adhesive surface down. Next, push
between the chassis and VGS-1.
6) Replace the cover and tighten the 2 screws.
VGS-1
VGS-1 connector
Spacer
(J30-1292-04)
4.5 x 24 x 3.0 mm
Rubber cushion
(G13-1995-04)
20 x 30 x 1.0 mm
VGS-1
Rubber cushion
(G13-1974-04)
21 x 21 x 2.5 mm