TK-3180
• Panel tuning
SCREW
TUBE
To Radio
• PC tuning
Connect the wires to the PCB in the connector case of
interface cable.
For output the wires out of the connector case, need to
process the connector case.
Remove the
screw
PCB layout
Shield
18
ADJUSTMENT
2: RED (RX AF OUTPUT)
3: BLACK (RX AF OUTPUT)
5: WHITE (MIC INPUT)
6: BROWN (MIC GND)
7: BLUE (PTT SW) GND → ON
8: YELLOW (PF SW)
10: BROWN (GND)
11: GREEN (5M)
BLU (7)
PTT SW
BRN (10)
100µ 10V
RED (2)
+
8Ω
AF Voltmeter
+
BLK (3)
100µ 10V
WHT
+
(5)
10µ 10V
Audio generator
BRN (6)
KPG-36
Connector case
100µ 10 V
8Ω
+
AF voltmeter
100µ 10 V
+
10µ 10 V
+
Audio generator
■ Repair jig (Chassis)
Use jig (part No. : A10-4077-04) for repairing the trans-
ceiver. Place the TX-RX unit on the jig and fit it with 14
screws.
■ Check Jig for the VGS-1
KENWOOD part No. : W05-1127-00
to transceiver
■ Nut wrench
In order to turn the volume nut and the channel selector
nut, use a recommendation tool.
KENWOOD part No. : W05-1123-00
to VGS-1