Cutting Height - Honda HRR216TDA Owner's Manual

BEFORE OPERATION
Mulching Plug (HRR)
The mulching plug helps to curve
the inside of the mower deck for
more efficient mulching.
Install and remove the mulching
plug by raising the rear discharge
guard as shown. The mulching plug
only fits one way. Remove the
mulching plug when using a grass
bag.
Side Discharge Chute
(HRS)
To discharge clippings to the side,
install the side discharge chute as
shown.
Remove the side discharge chute
when mulching.

Cutting Height

Set all four adjustment levers to the
same cutting height position. Each
position changes the height
approximately 1/2 inch (13 mm).
To adjust cutting height, pull each
adjustment lever toward the wheel,
and move it into another notch.
If you are not sure what cutting
height to select, start with a high
setting and check the appearance of the lawn after mowing a small
area. Readjust cutting height if necessary.
14
SIDE
DISCHARGE
GUARD
SIDE DISCHARGE CHUTE
ADJUSTMENT LEVERS
REAR
DISCHARGE
GUARD
MULCHING
PLUG