Table of Contents
Advertisement
3
Click the Submit Password button.
The Changing Admin Password page will appear.
4
Click Back to the Configuration page in the Changing Admin
Password page.
To change the network settings on the Control Unit:
1
Click Configure Network in the Configuration page. For more
information about accessing this Web page, refer to pages 33 through
34.
The Configure Network page will appear.
2
Change the default Host Name assigned to your Control Unit during
manufacturing. You may want to use a name that identifies the room
where the Control Unit is installed.
The factory default Host Name is "hawksetup".
3
If your network uses Static IP addresses, select Static IP as the
Network Type and change the factory default IP Address.
The factory default IP Address is "192.168.1.10".
4
Review the settings of the other fields displayed in the Configure
Network page and make changes as needed.
5
Click the Submit Configuration button.
The Validating Network Configuration page will appear.
6
Review the network settings displayed in the Validating Network
Configuration page. If you're satisfied with the settings, click the Set
Configuration button. Otherwise, click the Go Back button to return to
the Configure Network page.
A Web page will appear indicating that the configuration files are being
updated and the Control Unit will be restarted.
NOTE: If your network uses a naming service, it may take awhile for a
new Host Name to come into effect. If you experience difficulties
reconnecting to the Configuration or Sessions page using a new Host
Name, try using the IP Address instead.
Configuring a Networked Control Unit
35
Advertisement
Table of Contents
