Table of Contents
Advertisement
the spanner in the opposite direction to the direction
of rotation (Caution! left-hand thread).
•
When loosening and tightening the saw blade nut,
there is a risk of injury from the teeth of the saw blade.
You should therefore always ensure that your hand is
shielded by the blade guard when doing this. Always
use a socket spanner with a shaft that is long enough
to allow this. The arrow in the diagram shows the area
where you should operate the socket spanner when
loosening or tightening the nut.
Fitting a trimmer guard and
Superauto II 1" trimmer head
•
Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
To fit the trimmer head, first separate the two halves
(see diagram). Proceed as follows:
ASSEMBLY
K
G
K
F
B
I
C
J
I
A
Insert a finger into the centre hole of the cover (I) while
grasping the cover with your other fingers. Using the
index finger and thumb of your other hand, release the
two catches (J) that engage in the cut-outs in the
bottom half (K). Pull apart the trimmer head, grasping
the cover firmly.
•
Place the cover (I) and the support flange (F) on the
output shaft.
•
Fit the nut (G). Tighten the nut to a torque of 35-50 Nm
(3.5-5 kpm). Use the socket spanner in the tool kit.
Grasp the handle of the spanner as close to the
trimmer guard as possible.
•
To tighten the nut, turn the spanner in the opposite
direction to the direction of rotation (Caution! left-hand
thread).
•
Fit the bottom half of the trimmer head (K) to the cover
(I) by pressing them together, with the cut-outs on the
bottom half aligned with the catches on the cover.
•
To dismantle, follow the instructions in the reverse
order.
Fitting other guards and cutting
attachments
•
Fit the trimmer guard/combination guard (A) intended
for use with the trimmer head/plastic blades. Hook the
–
English
15
Hide quick links:
Advertisement
Table of Contents
