Setting Basic Functions; Changing The Needle Stop Position - Brother S-7000DD Instruction Manual

4. USING THE OPERATION PANEL (ADVANCED OPERATIONS)

4-4. Setting basic functions

If you turn on the power switch while pressing the thread trimming disable/F1 key, you can then make the following settings.
Setting item
Needle stop position
Correction
Slow start
Thread trimming disable
Thread wiping
Needle tip illumination lamp brightness
adjustment

4-4-1. Changing the needle stop position

This sets whether the needle bar stops in the needle up stop position or the needle down stop position when the treadle is
returned to the neutral position and sewing stops.
Activating setting mode
1
(While pressing the thread trimming disable/F1 key, turn on the
power switch.)
Setting the needle up stop and needle down stop positions
2
3
4
21
Four columns
display
Updn
Corr
SLoW
trdi
WiP
LAMP
(Setting value)
(Setting item)
Initial value
Needle down
Refer to"4-4-1".
stop
None Refer to"4-4-2".
Setting can be carried out by pressing the
None
slow start/F2 key.
Setting can be carried out by pressing the
None
thread trimming/F1 key.
Enabled Refer to"4-4-3".
Fully
Refer to the Service Manual.
illuminated
(Setting item)
・ When the D
display will appear.
・ When the C
display will appear.
Needle up stop
...
Needle down stop
...
NOTE:
If the SEL key (1) is pressed once more,
the ABCD indicator will switch off and the
display will return to the setting item.
The setting will be stored and the display will
return to the setting item.
Setting mode will be exited and normal
operation will be possible.
S-7000DD
Reference item
0517D
key is pressed, the "UP"
key is pressed, the "dn"
0518D
0519D
0520D