Chevrolet Corvette 2014 Owner's Manual page 112

pressing SEL on any page will stop
the current lap timer and start a new
lap. Also, pressing and holding SEL
on any page will stop the lap timer.
Shows the
current oil temperature in either
degrees Celsius (°C) or degrees
Fahrenheit (°F).
Shows the current oil
pressure in either kilopascal (kPa) or
in pounds per square inch (psi).
Shows the
current battery voltage.
Shows the
temperature of the transmission fluid
in either degrees Celsius (°C) or
degrees Fahrenheit (°F).
Shows tire
temperature status as either Cold,
Warm, or Hot. Warm is typical for
normal driving while Hot is typical
for aggressive driving. Unknown
may be displayed if tire temperature
information is unavailable.
While the audio app is open, use
or to change the radio station or
seek to the next or previous track,
depending on the current audio
source. Press SEL to enter the
Audio menu. In the Audio menu
browse for music, select from the
favorites, or change the audio
source.
Press SEL to enter the Phone
menu. In the Phone menu, if there is
no active phone call, view recent
calls, or scroll through contacts.
If there is an active call, mute or
unmute the phone or switch to
handset or hands-free operation.
If equipped, press SEL to enter the
Navigation menu. Displays a map or
turn by turn directions. If there is no
active route, press to resume the
last route and turn the voice
prompts on/off. If there is an active
route, press SEL to cancel route
guidance or turn the voice prompts
on/off.
Press SEL to enter the Settings
menu. Use or to scroll
through items in the Settings menu.
Press while Units is
displayed to enter the Units menu.
Choose US or Metric units by
pressing SEL while the desired item
is highlighted.
Press
the Display Theme menu. Select
from Link to Drive Mode, Track,
Sport, or Tour for the cluster theme.
The Speed
Warning display allows the driver to
set a speed that they do not want to
exceed. To set the Speed Warning,
press when Speed Warning is
displayed. Enable the speed
warning and then use
adjust the value. Press SEL to set
the speed. Once the speed is set,
to enter
or to