General Safeguards; Electrical Connections - DeLonghi DDSE30 Instructions For Use Manual

Table of Contents

Advertisement

use in compliance with its intended use
this appliance is intended for domestic use only.
use this appliance only as described herein. these instruc-
tions do not intend to cover every possible condition and
situation that may arise.
Common sense and caution should be applied when instal-
ling, operating and storing any appliance.

General safeguards

Do not install the appliance in rooms containing gas, oil
or sulphur. Do not install near sources of heat.
Do not use the appliance on sloping surfaces.
Keep the appliance at least 2 ft (61cm) away from flam-
mable substances (alcohol etc) or pressurised containers
(e.g. aerosol cans).
Do not rest heavy or hot objects on top of the applian-
ce.
Always transport the appliance upright, NOT on its side.
Remember to drain the condensate tank before moving
the appliance.
if the appliance was transported on its side, you must
wait at least 6 hours before using it (24 hrs is recom-
mended).
EnVIRonMEntAL InFoRMAtIon: this unit contains
fluorinated greenhouse gases covered by the Kyoto
Protocol. avoid perforating the refrigerant circuit of the
appliance.
maintenance and disposal must be carried out by quali-
fied personnel only (R410a, GWP=1975).
• The materials used for packaging can be recycled.
You are therefore advised to dispose of them in special
differentiated waste collection containers.
• Do not use the appliance outdoors.
• Do not obstruct the air intake or outlet.
uSE
Read these instructions carefully before using the appliance.
• Keep these instructions.
if the appliance is transferred to other owners, they
should also be given these instructions.
Failure to respect the instructions may result in injury or
damage to the appliance.
the manufacturer is not liable for damage deriving from
failure to follow these instructions.

Electrical connections

Wait at least 6 hour after transporting the appliance before
starting it.
Before plugging the appliance into the outlet, check
that:
• The outlet, power supply corresponds to the working
voltage indicated on the rating plate.
The power outlet, and electrical circuit are adequate for
the appliance.
The power outlet, matches the plug. If this is not the
case, have the plug replaced by a qualified electrician;
The outlet is properly grounded.
Setting it up for use
Position the appliance in the room to be dehumidified.
It is essential to leave a free space of at least 2 ft (61 cm) in
front and on the top of the dehumidifier, so as not to obstruct
the air inlet and outlet.
for efficient ventilation it is advisable to leave a space of at
least 2-4 inches (5-10 cm) all around the appliance.
Applying the castors
if you wish to apply the castors to the appliance, proceed as
follows:
1) make sure the appliance is unplugged and the tank is empty.
2) Remove the rubber caps from the base of the appliance
by pulling them out hard, using pliers if necessary (see
figure 1/a).
3) apply the castors by inserting their pins into the holes
(see figure 1/b).
tools needed and estimated time
tools required: pliers if necessary.
assembly time: approx. 5 minutes.
4
use
en

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents