Gigabyte G1.Sniper Z97 User Manual page 26

3/4) CPU_FAN/SYS_FAN1/SYS_FAN2/SYS_FAN3 (Fan Headers)
All fan headers on this motherboard are 4-pin. Most fan headers possess a foolproof insertion design.
When connecting a fan cable, be sure to connect it in the correct orientation (the black connector wire is
the ground wire). The speed control function requires the use of a fan with fan speed control design. For
optimum heat dissipation, it is recommended that a system fan be installed inside the chassis.
• Be sure to connect fan cables to the fan headers to prevent your CPU and system from
• These fan headers are not configuration jumper blocks. Do not place a jumper cap on the headers.
5) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The Intel
RAID 5, and RAID 10. Refer to Chapter 3, "Configuring SATA Hard Drive(s)," for instructions on configuring a
RAID array.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives
• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does
• A RAID 10 configuration requires four hard drives.
• To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SATA
DEBUG
Hardware Installation
PORT
overheating. Overheating may result in damage to the CPU or the system may hang.
SATA3
7
7
are to be used, the total number of hard drives must be an even number.
not have to be an even number.)
Configuration," for more information.
1
CPU_FAN
1
SYS_FAN1/2/3
5 3 1
4 2 0
- 26 -
CPU_FAN:
Pin No. Definition
1 GND
2 +12V
3 Sense
4 Speed Control
SYS_FAN1/2/3:
Pin No. Definition
1 GND
2 Speed Control
3 Sense
4 VCC
Chipset supports RAID 0, RAID 1,
®
Pin No. Definition
1 GND
2 TXP
3 TXN
1
4 GND
1
5 RXN
6 RXP
7 GND