Sanyo PLC-WU3800 Owner's Manual page 57

Setting
Lamp control
This function allows you to change brightness of the screen.
Auto ............. The brightness according to the input signal
High .............. Brighter than the Normal mode.
Normal ......... Normal brightness.
Eco ............... Lower brightness reduces the lamp power
P Note:
Lamp mode cannot be changed for a while after turning
on the projector. Lamp needs some time to stabilize
after the power is turned on. Stored lamp mode will be
active after the lamp is stabilized.
Remote control
This projector provides two different remote control codes:
the factory-set initial code (Code 1) and the secondary code
(Code 2). This switching function prevents remote control
interference when operating several projectors or video
equipment at the same time.
When operating the projector in Code , both the projector
and the remote control must be switched to Code .
To change the code for the projector:
Select either Code 1 or Code  in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons
together for 5 seconds or more. After changing the code,
make sure the remote control operates properly.
P Note:
• When different codes are set on the projector and on
the remote control, any operation cannot be made. In
that case, switch the code on the remote control to fit
the code on the projector.
• If the batteries are removed from the remote control for
a long period of time, the remote control code will
be reset.
56
(between High and Eco mode).
consumption and extends the lamp life.
Remote control