Sanyo PLC-WU3800 Owner's Manual page 51

Setting
Enter a Logo PIN code
Use the Point
Point button to fix the number and move the red frame
pointer to the next box. The number changes to
you fixed an incorrect number, use the Point
move the pointer to the number you want to correct, and
then enter the correct number.
Repeat this step to complete entering a four-digit
number.
After entering the four-digit number, move the pointer to
Set. Press the SELECT button so that you can start to
operate the projector.
If you entered an incorrect Logo PIN code, Logo PIN
code and the number (
moment. Enter the correct Logo PIN code all over again.
Change the Logo PIN code lock setting
Use the Point
press the SELECT button to close the dialog box.
Logo PIN code change
Logo PIN code can be changed to your desired four-
digit number. Press the Point
PIN code change and then press the SELECT button.
Logo PIN code dialog box appears, use the point
buttons to enter the current code.
input dialog box appears. Set a new Logo PIN code.
Be sure to note the new Logo PIN code and keep it
on hand. If you lost the number, you could no longer
change the Logo PIN code setting. For details on
PIN code setting, refer to "PIN code lock" on pages 57-
58.
CAUTION:
WHEN yOU HAVE CHANGED THE LOGO PIN
CODE, WRITE DOWN THE NEW PIN CODE
IN COLUMN OF THE LOGO PIN CODE NO.
MEMO ON PAGE 81, AND KEEP IT SECURELy.
SHOULD THE LOGO PIN CODE BE LOST OR
FORGOTTEN, THE LOGO PIN CODE SETTING
CAN NO LONGER BE CHANGED.
50
buttons to enter a number. Press the
) will turn red for a
buttons to switch On or Off, and then
button to select Logo
The New Logo PIN code
Enter a Logo PIN code
. If
button to
Change the Logo PIN code lock setting
Change the Logo PIN code
After a correct Logo PIN code
is entered, the following dialog
box appears.