Honda 2003 Odyssey Owner's Manual page 336

Main Menu Table of Contents
5. Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end into
the slot.
6. Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ''TOP.''
7. Push the electrical connector onto
the new bulb. Make sure it is
connected securely.
Turn on the headlights to test the
new bulb.
8. (Driver's side)
Reinstall the air intake cover.
Replacing the Front Side Marker/
Turn Signal and Parking Light
Bulb
HOLDING CLIP
1. If you are changing the bulb on
the driver's side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger's side, turn
the steering wheel to the left.
2. Use a flat-tipped screwdriver to
remove the two holding clips from
the inner fender.
3. Pull the inner fender cover away
from the fender and bumper.
Maintenance
Lights
CONTINUED
333