D-Link mydlink DNR-322L User Manual page 91

Section 4 - Troubleshooting
Respond to a Critical RAID Volume
How the unit responds to a critical RAID Volume depends on the RAID level of your Volume and whether you have a spare
drive available:
For RAID 1 Volumes, if a spare drive is available, the RAID Volume will begin rebuilding itself automatically.
For RAID 1 Volumes, when no spare drive is available, you must replace the failed disk drive. The RAID Volume will begin rebuilding itself when you install the new disk drive.
RAID 0 Volumes go offline after a disk drive failure. A RAID 0 volume cannot be rebuilt. All data on the volume will be lost.
Restore the Default Administrator's Password
If you forget the password, you can reset the password for admin to the default password: <empty>. Press and hold the reset
button for 5 seconds until the Power LED flashes three times. The Administrator password will now be blank.
Caution
When you reset or recover your unit, sometimes it will cause data corruption. Back up your recorded data before resetting
your unit.
Install ActiveX
If you cannot see the complete page of the system when using Internet Explorer, the ActiveX installation process may not be
complete.
Step 1: Click Live View/Playback on the top right.
Step 2: The browser will ask whether to install ActiveX.
Step 3: Click the upper bar to begin the installation process.
Step 4: Click Install to complete the process.
Cannot Log in to the Unit through Internet Explorer
1. Check the settings of your anti-virus software.
2. Adjust the settings of or disable your anti-virus software.
D-Link DNR-322L User Manual 87