Cleaning And Flushing - Honda BF75-100 Owner's Manual

Cleaning and Flushing
After each use in salt water or dirty water, thoroughly clean and flush the
outboard motor.
1. Wash the outside of the outboard motor with clean, fresh water.
2. Flush the cooling system, using the Honda flush kit supplied with the
outboard motor.
a. Attach a hose from a fresh water faucet to the flush kit hose coupler.
b. Remove the propeller, and clip the flush kit rubber fitting over the water
intake as shown.
c. Turn on the fresh water supply to the hose.
d. Start the engi'ne and run in neutral for 10 minutes.
l
For safety, the propeller must be removed.
l
Be sure the outboard motor is securely mounted, and do not leave it
unattended while running.
CAUTION: Running the engine without water can cause serious engine
damage due to overheating. Be sure that water flows from the water
check tube while the engine is running. If not, stop the engine and
determine the cause of the problem.
KIT
WAiER
HOSE
30