Dell OptiPlex 3020 Owner's Manual page 53

Small form factor
Hide thumbs Also See for OptiPlex 3020:
Table of Contents

Advertisement

Error Message
Description
Bad command or
Ensure that you have spelled the command correctly, put spaces in the proper
file name
place, and used the correct pathname.
Bad error-
The floppy or hard drive controller detected an uncorrectable read error.
correction code
(ECC) on disk read
Controller has
The hard drive or the associated controller is defective.
failed
Data error
The floppy or hard drive cannot read the data. For the Windows operating system,
run the chkdsk utility to check the file structure of the floppy or hard drive. For
any other operating system, run the appropriate corresponding utility.
Decreasing
One or more memory modules may be faulty or improperly seated. Re-install the
available memory
memory modules and, if necessary, replace them.
Diskette drive 0
A cable may be loose or the computer configuration information may not match
seek failure
the hardware configuration.
Diskette read
The floppy disk may be defective or a cable may be loose. If the drive access light
failure
turns on, try a different disk.
Diskette
The floppy drive controller may be faulty.
subsystem reset
failed
Gate A20 failure
One or more memory modules may be faulty or improperly seated. Reinstall the
memory modules and, if necessary, replace them.
General failure
The operating system is unable to carry out the command. This message is usually
followed by specific information—for example, Printer out of paper. Take the
appropriate action to resolve the problem.
Hard-disk drive
The hard drive failed initialization.
configuration
error
Hard-disk drive
The hard drive failed initialization.
controller failure
Hard-disk drive
The hard drive failed initialization.
failure
Hard-disk drive
The hard drive failed initialization.
read failure
Invalid
The computer configuration information does not match the hardware
configuration
configuration.
information-
please run SETUP
program
Invalid Memory
DIMM1 slot does not recognize a memory module. The module should be re-
configuration,
seated or installed.
53

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents