Installing The Input/Output (I/O) Panel
1.
Slide the I/O panel into its slot on the computer.
2.
Replace the screw that secures the I/O panel.
3.
Route the three cables through the metal clips.
4.
Connect the three I/O panel and FlyWire cables to the system board.
5.
Install the:
– optical drive
– hard drive
– bezel
– cover
6.
Follow the procedures in
Removing The System Board
1.
Follow the procedures in
2.
Remove the:
– cover
– bezel
– optical drive
– hard drive
– heatsink
– processor
– memory
– expansion cards
– I/O panel
3.
Follow the steps below to remove the system board:
a) Disconnect and un-thread all the cables connected to the system board.
b) Remove the screws that secure the system board to the computer.
c) Slide the system board towards the front of the computer and tilt to a 45–degree angle.
d) Lift the system board out of the computer.
22
After Working Inside Your Computer .
Before Working Inside Your Computer .