Wiring Connection - LG LT-E1820CL Manual

5. Wiring Connection

• Open the control box cover and connect the Remote controller cord and Indoor power wires.
Indoor
power cord
Remote
controller
cord
• Heat Pump Model
• Cooling Model
The power cord connected to the outdoor unit should be complied
with the following specifications (Rubber insulation, type H05RN-F
approved by HAR or SAA).
NORMAL
CROSS-SECTIONAL
AREA 2.5mm
If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufac-
turer or its service agent.
WARNING
Make sure that the screws of the terminal are free from looseness.
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Control box cover
Control box cover
fitting screw(2 units)
Terminal Block of Indoor Unit
3(L) 4(N) 5 6 7
Terminal Block of Indoor Unit
3(L) 4(N) 5 6 7
CAUTION
- 25 -
Terminal Block of Outdoor Unit
1(L) 2(N) 3(L) 4(N)
Power Cord
Terminal Block of Outdoor Unit
1(L) 2(N) 3(L) 4(N)
Power Cord
The connecting cable connected to the indoor and outdoor unit should
be complied with the following specifications (Rubber insulation,
type H05RN-F approved by HAR or SAA).
NORMAL
CROSS-SECTIONAL
AREA 0.75mm
[Air inlet side view]
5 6 7 8
5 6 7 8
LGE Internal Use Only