Wax Bag – Tr8500 Int'l And Tr9000Hr Dom/Int'l - Life Fitness 9000HR Service Manual

Life Fitness Models 9000HR, 8500, and T9i Treadmills
How To... Replace the Wax Bag – TR8500 Int'l and TR9000HR Dom/Int'l
Special Tools Required: None
1. Raise the unit to its highest elevation.
2. Turn the power OFF at the ON/OFF switch, and then unplug the unit
from the electrical outlet.
3. Pull out the three push rivets that fasten the front edge of the wax tray to
the bottom of the treadmill frame then, lower the wax tray. If necessary,
use a flat-edge screwdriver to pry off the rivets. The rivets are reusable.
Set the front edge of the wax tray down, with the wax bag on top of it.
4. Clamp the wax bag hose to prevent any residual wax from seeping out
of the bag. Work the wax bag hose off the barbed fitting on the wax
pump, which is the inlet side. Remove the hose clamp, and then discard the empty wax bag.
5. Reattach the clamp to the new wax
bag hose.
6. Place the new wax bag on top of the
tray so its flange is facing out toward
the front of the treadmill. The wax
bag hose is now near the access
hole at the bottom of the motor pan.
7. Cut off the end of the new wax bag
hose approximately one half inch
from the end. Feed the hose through
the access hole in the bottom of the
frame, and then push the hose onto
the barbed fitting (wax pump inlet
side). Once the hose is secured to
the barbed fitting, release the hose
clamp.
8. Align two holes of the wax bag flange with the two holes at the front edge of the wax tray and at the bottom of the
treadmill frame. Attach the wax tray and wax bag to frame with two push-rivets. Push these rivets in as far as
possible, then insert the third rivet.
9. Log maintenance repair.
Wax
Bag
Wax
Push Rivets
Tray
26
Engage
Release
Frame
Motor
Pan
Hose
Clamp
Wax Bag
Hose
Barbed
Connetor