ECS H61H-G11 Manual page 21

16
F_USB1: Front Panel USB header
The motherboard has one USB 2.0 header supporting two USB 2.0 ports. Addition-
ally, some computer cases have USB 2.0 ports at the front of the case. If you have
this kind of case, use auxiliary USB 2.0 connector to connect the front-mounted
ports to the motherboard.
Pin
1
2
3
4
5
6
7
8
9
10
Please make sure that the USB cable has the same pin assignment as
indicated above. A different pin assignment may cause damage or system
hang-up.
FPD: FPD power connector
The motherboard must provide additional power for the internal flat panel display
(both panel and backlight inverter) via an FPD power connector.
Pin
1
2
3
4
5
6
7
8
HDD_PW: HDD power connector
This connector is used to provide power for the HDD.
Pin
1
2
3
4
Signal Name
USBPWR Front Panel USB Power
USBPWR Front Panel USB Power
USB_FP_P0- USB Port 0 Negative Signal
USB_FP_P1- USB Port 1 Negative Signal
USB_FP_P0+ USB Port 0 Positive Signal
USB_FP_P1+ USB Port 1 Positive Signal
GND Ground
GND Ground
Key No pin
NC Not connected
Signal Name
BKLT_EN
BKLT_PWM
BKLT_PWR
BKLT_PWR
BKLT_GND/Brightness_GND
BKLT_GND/Brightness_GND
Brightness_UP
Brightness_DOWN
Signal Name
+12V
+5V
+3.3V
GND
Installing the Motherboard
Function
Function
Backlight enable
Backlight control
Backlight inverter power
Backlight inverter power
Ground (shared)
Ground (shared)
Panel brightness increase
Panel brightness decrease