ECS 760GX-M Manual page 37

HT_Width<In/Out> (Auto)
This item shows HyperTransport
size is automatically calculated by the CPU. Therefore, We strongly recommend that you
do not change this setting.
HT-Speed (800 MHz)
This item shows the bus frequency of Local Descriptor Table. Its default is set as 800
MHz.
Max Memclock (Mhz)(Auto)
When DDR Timing Setting by is set to Manual, use this item to set the DRAM frequency.
1T/2T Memory Timing (Auto)
This item allows you to adjust the DRAM timing. Please note that it only support the K8
CG version and the following version. We recommend that you leave this item at the
default value.
CAS# latency (Tcl) (Auto)
This item determines the operation of SDRAM memory CAS (column address strobe). It
is recommended that you leave this item at the default value. The 2T setting requires
faster memory that specifically supports this mode.
Press <Esc> to return to the Advanced Chipset Features page.
AGP & P2P Bridge Control (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
AGP Aperture Size
AGP Fast Write Support
AGP Data Transfer Rate
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values
AGP Aperture Size (128M)
This item defines the size of aperture if you use an AGP graphics adapter. The AGP
aperture refers to a section of the PCI memory address range used for graphics
memory. We recommend that you leave this item at the default value.
AGP Fast Write Support (Disabled)
This item controls the AGP bus Fast Write capability. Fast Write allows the AGP device
to act like a PCI device. This allows it to skip the main memory and directly access the
data that improves the AGP read performance.
AGP Data Transfer Rate (Auto)
You can select the AGP device data transfer rate capability.
Press <Esc> to return to the Advanced Chipset Features page.
TM 's bus size of Local Descriptor Table (LDT). The bus
Phoenix-AwardBIOS CMOS Setup Utility
Advanced Chipset Features
[128M]
[Disabled]
[Auto]
Menu Level
F6:Fail-Safe Defaults F7:Optimized Defaults
Using BIOS
Item Help
31