Honda HRC216HXA Owner's Manual page 60

SET-UP
7. From the grass bag
side of the handle,
insert the stud on
the end of the
handle support plate
through the handle
support hanger.
Make sure the stud
goes through both
holes in the handle
support hanger.
8. Install an 8 mm
self-locking nut on
the stud.
9. Tighten the locknut
on the stud at each
end of the handle
support plate.
10. Repeat Steps 5
through 9 to install
the handle support
on the other side of
the lawn mower.
Lock Nut Torque:
15 ft-lb (21 N•m)
11. Position cable ties at
the locations shown.
58
STUD
HANDLE
SUPPORT
PLATE
LEFT HANDLE
HANDLE SUPPORT
PLATE (2)
8 MM LOCK
NUT
LEFT HANDLE
HANDLE
SUPPORT
HANGER
RIGHT HANDLE
HANDLE
SUPPORT
HANGER (2)
CABLE
TIES
3 in (75 mm)
12 in (300 mm)
8 MM LOCK
NUT
10 in (250 mm)