Honda HRC216HXA Owner's Manual page 45

6. While holding the drive
clutch lever all the way
forward, look through the
cover plate hole and check
the position of the control
arm.
The center of the notch on
the control arm should align
with the index mark on the
transmission case.
7. If adjustment is necessary,
loosen the drive clutch cable
lock nuts with a 10 mm
wrench and move the
adjuster up or down as
required.
8. Tighten the lock nuts.
9. Operate the clutch lever
several times and recheck
control arm alignment.
10. After the control arm is
precisely aligned, re-install
the transmission cover plate.
11. Start the engine and operate
the drive clutch lever. Check
to be sure the drive clutch
lever operates properly.
If the drive clutch lever does
not operate properly after the
cable is correctly adjusted,
take the mower to an
authorized Honda servicing
dealer for repair.
SERVICING YOUR LAWN MOWER
CONTROL
ARM
NOTCH
INDEX
MARK
LOCK NUTS
ADJUSTER
43