Removing The Air Duct - Fujitsu PRIMERGY TX100 S1 Options Manual

Removing the air duct

4.2 Removing the air duct
I
When removing the air duct, make sure that you do not damage the heat
sink on the system board.
Figure 6: Removing the air duct
Ê Open the server (see
Ê Unhook the cables from the brackets on the air duct.
Ê Remove any connected cables that are impeding your work.
Ê Unlock the air duct by pressing the locking clip in the direction of the arrow
(1).
Ê While keeping the locking clip pressed, lift the air duct out of its housing in
the direction of the arrow (2).
22
section "Opening the server" on page
Options Guide
Preparation
17).
TX100 S1