Table of Contents
Advertisement
Right side panel
HOLD
REMOTE
POWER
LEFT
OUTPUT
PHONES
❶ [POWER] switch
Used to turn the power on or off.
While the power is off, you can turn on the power
by sliding up and release the switch.
While the power is on, you can turn off the power
by sliding up and holding the switch for two sec-
onds.
<Memo>:During playback or recording, you
cannot turn off the power.
❷ [REMOTE] connector
By connecting a Panasonic (or equivalent) remote
shutter release to this connector, you can start or
stop recording using the remote shutter release.
❸ [USB] connector
By connecting to a personal computer using a USB
cable, you can transfer audio data, copy audio files,
etc. between the unit and a personal computer.
❹ [DC-IN] connector
Provided for connecting the optional AC adaptor
(AC12) or an external battery power supply to run
the unit.
When a plug is connected to this connector, the
internal battery power is disabled.
<Caution>:When you connect or disconnect
a plug to this connector, make sure that the
power is off.
Features and controls
USB
DC-IN
9-24V
RIGHT
SD
RTN IN
❺ [PHONES] connector
Provided for connecting headphones for monitor-
ing.
❻ [OUTPUT] connectors (L and R)
These connectors output the recorder's output sig-
nals.
❼ [RTN IN] connector
Provided for connecting the stereo output of an ex-
ternal device.
You can monitor the signal received from this con-
nector via headphones.
❽ [SD-CARD] slot
This slot is located inside the battery compartment
cover.
To set an SD card to the slot, hold an SD card with
the label side facing to the battery compartment,
and press the card into the slot until you hear a
click.
To remove an SD card, firmly press the card into
the slot and release it. The card should pop partially
out of the slot. Remove the card from the slot.
<Memo>:You can use the following SD card
types with the unit.
SD, SDHC, MiniSD, MiniSDHC,
MicroSD, MicroSDHC
* When you use a MiniSD or microSD card, use
the appropriate card adaptor.
* You cannot use an SDXC card.
❾ Battery compartment
To run the unit on battery power, set four AA bat-
teries into this compartment. It is recommended to
use alkaline or rechargeable nickel hydride batter-
ies.
To remove battery compartment, open the battery
compartment cover and pull up the ribbon attached
to the battery compartment.
E-6
Advertisement
Table of Contents
