2. Pull the Upright Wire (77) and the ground wire
(A) through the indicated hole in the Base (91).
Attach the ground wire (A) to the Base (91) with
a #8 x 1/2" Ground Screw (10).
Press the Grommet (75) into the square hole in
the Base (91).
3. Identify the Left Upright (88). Have a second
person hold the Left Upright near the Base (91).
See the inset drawing. Tie the wire tie in the
Left Upright (88) securely around the Upright
Wire (77) about 8 in. (20 cm) down from the end.
Then, pull the other end of the wire tie until the
Upright Wire is routed completely through the
Left Upright. Note: The Upright Wire should bend
so that the connectors are pointing downward as
you pull it through the Left Upright.
2
Hole
77
10
3
77
Wire
88
8
75
A
91
88
Wire
Tie
Tie
77
91
77