Table of Contents
Advertisement
HS-500 General Operation
Some General Notes on Installation
Before setting up the HS-500, please make sure you have read the Warnings and Precautions section on
page 3. The internal wiring between the SE-500 and TLM-702 is already installed and ready to go.
Setting Up
Place the HS-500 on a stable, flat surface, such as a desk with the handle of the case facing towards you.
Ensure that the larger of the two sections, which has the handle attached, is on top.
Unlock the two locks and lift the lid.
The hinges at the back of the HS-500 have been designed so that once the lid is at an angle of 45 - 90
degrees it can be slid to the left and removed.
WARNING ! Do not allow the lid to go beyond 90° as it may damage the case. Once
the lid is upright, slide it to the left and remove it.
6
Advertisement
Table of Contents
