Changing The Engine Oil And Filter - Honda 2010 Accord Coupe Owner's Manual

Changing the Engine Oil and Filter

Always change the oil and filter
according to the maintenance
messages shown on the information
display. The oil and filter collect
contaminants that can damage your
engine if they are not removed
regularly.
Changing the oil and filter requires
special tools and access from
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lift for this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
technician.
Run the engine until it reaches
1.
normal operating temperature,
then shut it off.
302
WASHER
OIL DRAIN BOLT
4-cylinder models
Open the hood, and remove the
2.
engine oil fill cap. Remove the oil
drain bolt and washer from the
bottom of the engine. Drain the oil
into an appropriate container.
2010 Accord Coupe
WASHER
V6 models
OIL DRAIN BOLT
Remove the oil filter and let the
3.
remaining oil drain. A special
wrench (available from your
dealer) is required.
Make sure the oil filter gasket is
not stuck to the contacting surface
of the engine. If it is, remove it
before installing a new oil filter.