Connecting To A Video Imaging Device - Hitachi 37PD5000 User Manual

INSTALLATION INSTRUCTIONS

Connecting to a Video Imaging Device

(1) Make sure that the power switch of the monitor is turned off.
(2) Make sure that the power switch of the imaging device is turned off.
(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this
device and the signal output terminal of the imaging device.
VTR
S-video/Composite video
20 18 16 14
21 19 15 13
Do not connect both 17
plugs at the same time.
Use either of them.
Adaptor
Adaptor
with Cable
(37") (55")
S-video can not
be used. Video disc player
With RGB component setup
Applicable video signals for each input terminal (See PRODUCT SPECIFICATIONS for details.
Terminal RCA/SCART
Signal CVBS S-video
AV1
AV2
AV3
AV4
RGB1
RGB2
Speaker (R)
12 10 8 6 4 2
11 9 5
7 3 1
VTR
SUB WOOFER
(55")
To audio sub woofer
To component video
equipments.
Please use the connection
cable suitable for the terminal
form of video equipment.
DVI
Component RGB PC STB
Monitor rear panel
(37")
(55")
Power
cord
DVD player
Use if the
video
equipment [An example of connecting video imaging devices]
has an
S video
input terminal
• If video equipment with an S video output terminal is used, cabling
by the S video cable is recommended to provide finer video
quality. (If an S video input terminal and a video input terminal of
AV3 connect to the monitor at the same time, S video input would
govern.)
• If the OUTPUT (MONITOR) terminal is connected to an external
monitor with a 75 Ohm terminal, it is possible to view the same
image as on the main unit. But it is possible to monitor only the
composite video signal from AV1, AV2, AV3 or AV4 input that is
displayed on the screen at the time.
• If the adaptor is applied to AV4 input as shown in the drawing, it is
not possible to receive RGB signal.
D-sub
RGB Component
Refer to Setup Menu.
Refer to Setup Menu.
Refer to Setup Menu.
Refer to Setup Menu.
Speaker (L)
(37")
(55")
Set-Top Box
)
Remarks
(