Advertisement
CLEANING
Dust bag full indicator (fig. 14)
The dust bag full indicator (G) indicates when
the dust bag needs changing or the vacuum
hose is blocked.
You should change the bag before the full
length of the indicator turns red to guarantee
optimum hygiene and the quality of the air
emitted into the environment.
Replacing the dust bag
To replace the bag, press the dust collection
compartment release button (M) and raise the
cover (Fig.15). Remove the dust bag carefully
and throw away in the rubbish.
Thread the new bag into the guides and push
as far as it will go (fig. 16).
Close the cover of the appliance by exerting
light pressure. The hose coupling automatically
enters the hole in the dust bag.
You should change the dust bag frequently
when vacuuming up very fine dirt such as flour,
talcum powder, etc.
NB:
The appliance has a safety device which pre-
vents the dust bag compartment cover being
closed when there is no dust bag in place.
Motor protection filter
To extend the working life of the appliance and
protect the motor, it is vital to keep the motor
protection filter clean.
To access the filter, open the dust collection
container, extract the dust bag and remove the
filter holder (fig. 17).
If the filter is not excessively dirty, simply
remove the dust.
If particularly clogged, it must be washed and
dried.
Make sure the filter is dry before putting it back
in the appliance.
When replacing the filter, make sure it is posi-
tioned correctly.
Air outlet microfilter
Remove the rear grill (L), take out the filter and
wash with water.
When completely dry, put back in place then
reposition the grill correctly (fig. 18).
Important warning:
Never use the appliance without the filter.
Never wash the filter in the washing machine or
dry with a hairdryer.
"PARKING" POSITION
The appliance is provided with a hose housing
system on the bottom to enable it to be put
away safely and tidily. (Fig.19)
If you have to interrupt cleaning for a brief
period, the appliance has a convenient hose
"parking" system. Insert the bracket on the
brush joint into the housing on the bottom of the
appliance. (Fig.20)
IMPORTANT WARNING
Malfunction of the appliance (low power, unusual
noise or complete breakdown) could be caused by
obstructed nozzles or hoses or faulty electrical
components.
Check the nozzles, dust bag and motor protection
filter.
If this does not resolve the problem, take the
appliance to an authorised service centre.
13
Advertisement
