Accessories Supplied - DeLonghi MW 767FP Instructions For Use Manual

Table of Contents

Advertisement

GB
9-04-2003
11:51

1.4 ACCESSORIES SUPPLIED

E L E C T R I C A L
A)
If your appliance comes fitted with a plug, it will incorporate a 13
Amp fuse. If it does not fit your socket, the plug should be cut off
from the mains lead, and an appropriate plug fitted, as below.
WARNING: Very carefully dispose of the cut off plug after removing
the fuse: do not insert in a 13 Amp socket elsewhere in the house
as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must be
protected by a 15 Amp fuse.
WARNING - THIS APPLIANCE MUST BE EARTHED
The wires in the mains lead are coloured in accordance with the
following code:
Green and yellow:
Blue:
Brown:
36
Pagina 36
chapter 1 - general
LOW WIRE RACK
Fan Oven Only mode:
for all types of traditional cooking,
especially cakes
HIGH WIRE RACK
Grill Only mode:
for all types of grilled food.
TURNTABLE
The turntable is used for all the
modes.
MEDIUM SPACER WIRE RACK
Microwave-only function
For all types of cooking on two levels
AT THE SAME TIME
(e.g., large amounts of food or differ-
ent foods).
See the instructions on page 55
PASTA COOKER (T) and SUPPORT
(M)
With pasta mode only. To use with
the support (M)
C O N N E C T I O N
IMPORTANT
E
Earth
Neutral
N
Live
Combined microwave + fan oven
mode and microwave + grill:
For rapid cooking of meat, pota-
toes, some leavened cakes and des-
serts and gratinéed dishes (for
example, lasagne)
( U . K .
If the plug is a moulded-on type, the fuse cover must be re-fitted
when changing the fuse using a 13 Amp Asta approved fuse to BS
1362. In the event of losing the fuse cover, the plug must NOT be
used until a replacement fuse cover can be obtained from your
nearest electrical dealer. The colour of the correct replacement fuse
cover is that as marked on the base of the plug.
B)
If your appliance is not fitted with a plug, please follow the
instructions provided below:
As the colours of the wires in the mains lead may not correspond with
the coloured markings identifying the terminals in your plug, proceed as
follows:
The green and yellow wire must be connected to the terminal in the plug
marked with the letter E or the earth symbol
green and yellow.
The blue wire must be connected to the terminal marked with the letter N
L
or coloured black.
The brown wire must be connected to the terminal marked with the letter
L or coloured red.
O N L Y )
or coloured green or

Advertisement

Table of Contents
loading

Table of Contents