Troubleshooting Methods According To Error Message - Kenmore 2927000 Service Manual

4-6. TROUBLE SHOOTING METHODS ACCORIDNG TO ERROR MESSAGE
For more detailed information for trouble shooting refer to page 42 to 51.
ERROR DECISION
ERROR
WATER
WATER LEVEL
SUPPLY dose not rise to
the set level in within
30 minutes.
DRAINAGE
Water is not
completely
within 12 minutes.
UNBALANCE
Laundry
unbalance during
spin.
LID
LID is opened in
OPEN
the course of
intermittent spin,
normal spin or
processing
reservation.
BASIS
NO INLET
lamp blinks
CAUSE FOR ERROR
OCCURRENCE
Water faucet is closed?
Water supply is interrupted.
Inlet V/V is clogged with
dirts.
Connector has bad contact
to the inlet valve.
BLUE 6-pin connector has
a bad connection at the main
board.
Is the drain hose located
properly?
Drain hose is folded or
clogged due to freeze or dirt.
Defective drain pump or the
BLUE 3-pin connector to the
main board has a bad
connection.
Laundry in the INNER TUB
is filled unevenly.
Washer is tilted.
Lid is opened during
intermittent spin or normal
spin?
Lid is opened while
processing reservation?
Check the connections to the lid
switch and at the WHITE 6-pin
connector at the main board.
31
REMEDY
Open water faucet.
Wait until water supply is
resumed.
Clean or replace filter.
Correct the connector
contact.
Same as above.
Drain hose properly positioned
at 0.9 ~ 1.2 m (36 ~ 48 inches)
above the floor.
Make sure the drain hose is not
plugged with a foreign object.
Check drain pump motor
contact. Replace the pump if
necessary.
Load the washer as evenly as
possible.
Adjust the leg.
Close the lid.
Close the lid.
Check the connections.
If the connection is good, check
the lead wire and replace it if
necessary.