Receiver Connections - Extron electronics DVI 201 Tx/Rx User Manual

Installation and Operation, cont'd

Receiver connections

The two transmitter models are in quarter-rack width
enclosures.
On the DVI 201 Rx (fi gure 2-11), the RS-232 Pass-Through
connector is on the front panel and the rest of the connectors are
on the rear panel.
Rear Panel
POWER
12V
0.4A MAX
1
8 9
Figure 2-11 — DVI 201 Rx Receiver's front and rear
panel connectors
On the HDMI 201 Rx (fi gure 2-12), all connectors are on rear
panel.
POWER
12V
0.4A MAX
1
8 9
Figure 2-12 — HDMI 201 Rx Receiver's rear panel
connectors
g
RS-232 connector — Connect a serial communications port to
this 3.5 mm, 3-pole captive screw connector for bidirectional
RS-232 communication. See RS-232 connector wiring, on
page 2-19 to wire the connector.
2-12 DVI 201 and HDMI 201 Tx/Rx • Installation and Operation
7
RS-232
PASS THRU
Tx Rx
DVI 200 Rx Series
Front Panel
DVI 201 Rx
2 DVI OUTPUT
10
HDMI 201 Rx
RS-232
HDMI OUTPUT
PASS THRU
Tx Rx
2
11 7
h
DC power input connector — Plug the included external
12 VDC power supply into either this 2-pole captive screw
connector or the power input connector on the transmitter
d
(item on page 2-11). See Power supply wiring, on page 2-18, to
wire the connector.
i
Receiver input connector — Connect one end of the two
separate TP cables from the transmitter (item
these RJ-45 female connectors.
C
Do not connect these devices to a computer data or
telecommunications network.
N
Connect transmitter output 1 to receiver input 1.
Connect transmitter output 2 to receiver input 2.
N
If necessary, test for proper cable connection (output 1 to
input 1, output 2 to input 2) as follows:
1. Plug both TP cables into the powered unit.
2. Momentarily connect either of the cables on the
opposite end into the unpowered unit's "2" connector.
If the unpowered unit's Power LED is lit, the
connection is correct.
If the unpowered unit's Power LED is not lit,
quickly unplug the connector on the unpowered end
and connect the other cable to the "2" connector.
See TP cable termination, on page 2-16, to properly wire the RJ-45
connectors.
j
DVI Output connector — Connect a DVI monitor or projector
for display of the transmitted direct digital image. See DVI
connector pin assignments on page 2-14 for pin assignments.
k
HDMI Output connector — Connect a HDMI monitor or
projector for display of the transmitted direct digital image.
See HDMI connector pin assignments on page 2-15 for pin
assignments.
DVI 201 and HDMI 201 Tx/Rx • Installation and Operation
e
on page 2-11) to
2-13