Table of Contents
Advertisement
im Vertrieb von
Installation, cont'd
Receiver rear panel connections
All connectors except the Configuration port are on the rear
panel (figure 2-7).
9
100-240V
0.3A
50/60 Hz
RGB OUTPUTS
R
G
H
V
15
Figure 2-7 — FOX 500 Rx receiver's connectors
i
RGB Outputs connectors —
BNC connectors — Connect
an RGBHV, RGBS, RGsB,
or RsGsBs video display
to these BNC connectors.
Connect the cables as shown
at right.
15-pin HD connector —
Connect an analog
VGA - UXGA RGB video
display to this 15-pin HD
female connector.
N
You can set the
receiver to output
the desired video
format, RGBHV,
RGBS, or RGsB.
RGBHV is the
default. See
"Format submenu"
in "Output
Configuration menu" in chapter 3, "Operation".
www.camboard.de
2-10
FOX 500 Tx/Rx • Installation
10
11
RS-232
FOX 500 Rx
OVER FIBER
OPTICAL
Tx Rx
NA
2* 1
B
AUDIO OUTPUTS
REMOTE
L
R
ALARM
RS-232
S
RGB
*
Tx Rx
1
2
OPTIONAL FOR
RETURN DATA
12
13
14
RGBHV
R
G
H
V
RGBS
R
G
H
V
RGsB
R
G
H
V
CAMBOARD Electronics
Do not tin the wires!
B
S
B
S
B
S
Tel. 07131 911201
Fax 07131 911203
j
Audio Outputs connectors —
3.5 mm mini jack —Plug a stereo mini plug into this connector.
5-pole captive screw connector —
screw connector outputs the transmitted unamplified,
line level audio. Connect audio devices, such as an audio
amplifier or powered speakers.
See figure 2-8 to properly wire a captive screw output connector.
Use the supplied tie-wrap to strap the audio cable to the
extended tail of the connector.
Tip
NO GROUND HERE.
Sleeve(s)
Tip
NO GROUND HERE.
Unbalanced Stereo Output
Figure 2-8 — Captive screw connector wiring for
stereo audio output
C
Connect the sleeve to ground (Gnd). Connecting
the sleeve to a negative (-) terminal will damage the
audio output circuits.
N The length of exposed wires is critical. The ideal length
is 3/16" (5 mm).
•
If the stripped section of wire is longer than 3/16",
the exposed wires may touch, causing a short circuit
between them.
•
If the stripped section of wire is shorter than 3/16",
wires can be easily pulled out even if tightly fastened
by the captive screws.
The volume level for the output can be set to either the
consumer level (-10 dBV) or the professional level (-4 dBu) via
the front panel or Ethernet or RS-232 control. See chapter 3,
"Operation", and chapter 4, "Remote Control", for details.
ce-info@camboard.de
FOX 500 Tx/Rx • Installation
This 5-pole, 3.5 mm captive
Tip
Ring
Sleeve(s)
Tip
Ring
Balanced Stereo Output
2-11
Advertisement
Table of Contents
