Minolta DiMAGE Xt Instruction Manual page 48

CHANGING THE MEMORY CARD - DATA-TRANSFER MODE
Never remove the card when the access lamp is red - the data or
memory card may permanently be damaged.
Windows 98 and 98 Second Edition
1. Turn off the camera.
2. Change the memory card.
3. Turn on the camera to remake the USB connection.
Windows ME, 2000 Professional, and XP
1. Stop the USB connection using the unplug-or-eject-hardware routine (p. 92).
2. Turn off the camera.
3. Change the memory card.
4. Turn on the camera to remake the USB connection.
Macintosh
1. Stop the USB connection by dragging the drive icon into the trash (p. 93).
2. Turn off the camera.
3. Change the memory card.
4. Turn on the camera to remake the USB connection.
USING USB DIRECT-PRINT
USB DIRECT-PRINT allows still images to be printed directly from a compatible Epson
printer. This function prints a single image on one sheet of paper. Index prints and TIFF
images cannot be printed with USB DIRECT-PRINT. To print index prints, see page 97.
Before each print run, check the printer settings; refer to the printer manual. A fully
charged battery should be used when the camera is connected to the printer. The use of
the AC adapter (sold separately) is recommended over the use of the battery.
94 D -
ATA TRANSFER MODE
Connect the camera to the printer using the camera's USB cable. The
larger plug on the cable is connected to the printer. Slide open the USB-
port cover and insert the smaller plug of the cable into the camera. Turn the
camera on. The USB Direct Print screen will be displayed.
Number of prints in the print run.
Strike through indicates unprintable file type.
Number of copies of the displayed image.
:move :sel. :print
The display button switches between
the single frame and index playback
formats.
The number of prints in the print run are displayed on the
Print file?
LCD monitor. Use the left/right keys to highlight "Yes," and
Number of prints: 7
press the center of the controller to start printing.
Yes No
Once printing begins, the operation can be canceled by
Printing finished.
pressing the center of the controller. The printing finished
message will indicate the end of the operation; turn the
OK
camera off to end the routine.
Use the left/right keys of the
controller to display the image to be
printed.
Press the up key to select the
number of copies to be printed. A
maximum of nine copies can be
selected. To deselect an image for
printing, press the down key until the
number of copies reaches zero.
Repeat the previous steps until all
the images to be printed are
selected. Press the central button of
the controller to begin the printing
routine.
95