Extension Tables - Delta 50-785 Instruction Manual

ASSEMBLING SUPPORT
BRACKETS TO ROLLER

EXTENSION TABLES

1. Place extension table (A) Fig. 7, on a firm supporting
surface. Align ends of support assembly (B) Fig. 7, with
slotted holes (C) at both sides of extension table (A), and
fasten support bracket assembly to extension table with
two 1/4-20 x 3/4" hex head screws and flat washers (D).
IMPORTANT: In the position shown in Fig. 7, make
certain the longer side of notches (E) will be closest to
hinge (F) of support table.
2. Assemble the remaining support bracket to other
extension table in the same manner.
ASSEMBLING ROLLER
EXTENSION TABLES TO
PLANER AND STAND
1. Assemble bracket clips (A) and leg support (F) Fig. 8,
to the front and rear lower stand brackets (B), one of
which is shown assembled, with two 1/4-20 x 3/4" hex
head screws (C), four flat washers (D) and two 1/4-20 hex
nuts (E). Adjustment to height of clip can be made later.
2. Align the three holes in the hinge of extension table
(G) Fig. 9, with three holes in the front of the planer base
(H) and loosely fasten the extension table to the planer as
shown with three M6 x 20MM hex flange screws (K) and
flange nuts. NOTE: Only finger tighten the three screws at
this time as height adjustment to the table will be
necessary as explained later in STEP 4. Later planer
models may not need flange nuts.
3. Place the notches at the bottom of extension table
support (B) Fig. 10, so the longer edge of the support
rests on the ledge of bottom support bracket (L) as
shown. Adjust bracket clip (A) so it contacts the horizontal
support bar (M). Tighten screw (N) after adjustment is
made. NOTE: Clip (A) acts as a safety device so the
extension table will not fall accidentally during operation
of the planer. Assemble the remaining roller extension
table to the rear of the planer in the same manner.
E
F
C
D
A
K
G
M
A
N
4
B
D
Fig. 7
F
B
E
D
C
Fig. 8
K
Fig. 9
B
Fig. 10
A
H
L