General Safety Rules - Homelite UT43103 Operator's Manual

WARNING:
Do not attempt to operate this unit until you
have read thoroughly and understand com-
pletely all instructions, safety information, etc.
contained in this manual. Failure to comply can
result in accidents involving fire, electric shock,
or serious personal injury.
READ ALL INSTRUCTIONS
BASIC SAFETY PRECAUTIONS
 Do not start cutting until you have a clear work area,
secure footing, and a planned retreat path from
the falling tree. Cluttered areas invite accidents.
 Keep ALL children, bystanders, visitors, and
animals out of the work area while starting or
cutting with the chain saw. Do not let visitors
contact chain saw or extension cord.
 Do not operate chain saw in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases, or dust. Chain saws create
sparks which may ignite the dust or fumes.
 WARNING: Use outdoor extension cords
marked SW-A, SOW-A, STW-A, STOW-A,
SJW-A, SJTW-A, or SJTOW-A. These cords
are rated for outdoor use and reduce the risk
of electric shock.
 Polarized Plugs. To reduce the risk of electric
shock, this tool has a polarized plug (one blade
is wider than the other). This plug will fit in a
polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician
to install the proper outlet. Do not change the
plug in any way.
 Make sure your extension cord is in good condi-
tion. When using an extension cord, be sure to
use one heavy enough to carry the current your
product will draw. A wire gauge size (A.W.G.)
of at least 14 is recommended for an extension
cord 50 feet or less in length. A cord exceeding
100 feet is not recommended. If in doubt, use
the next heavier gauge. The smaller the gauge
number, the heavier the cord. An undersized
cord will cause a drop in line voltage resulting
in loss of power and overheating.

GENERAL SAFETY RULES

Page 3 — English
 Inspect extension cords periodically and, if
damaged, have repaired by a licensed electri-
cian. Constantly stay aware of cord location.
Following this rule will reduce the risk of electric
shock or fire.
 Dress Properly - Wear snug fitting clothing.
Always wear heavy, long pants, long sleeves,
overalls, jeans or chaps made of cut resistant
material or ones that contain cut resistant
inserts. Wear non-slip safety footwear. Wear
non-slip heavy duty gloves to improve your
grip and to protect your hands. Do not wear
jewelry, short pants, sandals, or go barefoot.
Do not wear loose fitting clothing, which could
be drawn into the motor or catch the chain or
underbrush. Secure hair so it is above shoulder
level. Wear hearing and head protection.
 Heavy protective clothing may increase operator
fatigue, which could lead to heat stroke. During
weather that is hot and humid, heavy work should
be scheduled for early morning or late afternoon
hours when temperatures are cooler.
 Always wear eye protection with side shields
marked to comply with ANSI Z87.1 as well as
head protection when operating this equipment.
 Always be aware of what you are doing when
using the chain saw. Use common sense. Do
not operate the chain saw when you are tired,
ill, or under the influence of alcohol, drugs, or
medication.
 Do not expose the chain saw to rain.
 Do not use the chain saw in damp or wet locations.
 Always be aware of extension cord while oper-
ating chain saw. Take precautions to avoid
tripping over cord. Keep cord away from chain
and operator at all times. Never carry saw by
the cord or pull it to disconnect from receptacle.
Keep cord from oil and sharp edges.
 Stay alert and pay attention to what you are
doing. Use common sense when using this
unit.
 Keep all parts of your body away from the saw
chain when the unit is running.
 Always carry the chain saw by the front handle
with the unit unplugged and the guide bar
and saw chain positioned to the rear. When