Configuring And Controlling The Digicast Cmr5975 Media Router With Snmp; Required Snmp Information For Configuring A Digicast Product - Comtech EF Data CMR-5975 Installation And Operation Manual
Digicast media router s2 receiver
Hide thumbs
Also See for CMR-5975:
- Installation and operation manual (118 pages) ,
- Quick start manual (4 pages)
Table of Contents
Advertisement
Appendix E. Configuring and
Controlling the Digicast CMR-5975
In general, to configure the Digicast CMR-5975 for web-based management via Simple Network
Management Protocol (SNMP), first identify the required parameters listed below, then apply
them to the unit (Section E.2).
E.1
Required SNMP Information for Configuring a Digicast Product
To set up the Digicast CMR-5975 Media Router for SNMP, the following information must be
known:
1. Which version of SNMP is desired?
2. What SNMP Manager will be used
(informational only)?
3. What is the IP address of the SNMP
Manager?
4. What is the desired R/O Community String?
5. What is the desired R/W Community String?
Media Router with SNMP
E–1
SNMPv1
SNMPv2c
SNMPv3 (Not Supported)
.
.
.
Advertisement
Table of Contents
