AMT Datasouth Accel-7350 User Manual page 44

CAUTION
Page 43 of 46
• This error occurs if the printer detects
that a cut sheet paper is manually loaded
with excessiveskew.
• The ERROR lamp blinks, and the buzzer
sounds three times. The paper is ejected
and the printer enters the offline state.
Load paper again. If it is loaded straight,
the printer enters the online state.
• This error occurs if the front cover is
opened. The ONLINE lamp blinks.
Closing the front cover will remove the
cause of this error. The printer is in the
offline state while the cover is opened
Never open the front cover during printing.
Press the ONLINE key to stop printing and then open
the front cover.
• The jam sensor is defective when
loading fanfold
Press the ONLINE key to recover the
printer from this error.
The paper jam detection function is
disabled.
Remove paper dust from the jam sensor,
and load fanfold paper again.
The paper jam sensor may not function
properly when the sensor is exposed to a
direct light or sunlight especially when
using the rear tractor.
Chapter 5
.