C141-C012
−
UNTATN (UNIT ATTENTION Report Mode)
When the IDD is holding the Unit Attention condition, this specifies
methods of response to commands received from the INIT.
"1" (Report): Report the "CHECK CONDITION" status (SCSI
standard specifications) for commands other than the
INQUIRY and REQUEST SENSE commands.
"0" (Don't Report): Terminates all received commands normally
−
Spindle Motor Start Delay Timing
Indicates the delay of the spindle motor startup time. Note,
however, that SAS drives do not support the function for delayed
startup of the spindle motor and always report X'00.'
4.1 Control/Sense Commands
(the "CHECK CONDITION" status caused by
the UNIT ATTENTION condition is not
reported.)
4-17