HoMedics SC-650 Instruction Manual page 3

SC-650-A.qxd 10/2/06 6:10 PM
5. Use SCREW DRIVER to hook POTHOOK
into the hole of the LONG ARM CONNECTION PLATE.
6. Use ALLEN KEY to remove pre-set A SS E M B LY SCREW (located on the
bottom of the base) to release the LONG ARM CONNECTION PLAT E
into place.
Assembly
Screw
7. Use ALLEN KEY to attach POLE to BASE by inserting and turning
the 4 SCREWS tightly.
8. Slide POLE COVER down.
9. Replace PLATFORM by sliding it onto BASE and push down until it
snaps into place.
Page 5
Pothook
Long Arm
Connection Plate
Screws
4
Setting The Zero Point
and Balance
Before using the scale for the first time or
when the scale has been moved to another
place, you must set the zero point and
balance the scale before weighing yourself.
Zero Point
1. With nothing on the PLATFORM, slide
the UPPER and LOWER sliding weights
to ZERO.
2. To set the POINTER TIP in the middle of
the OVAL you must use the ADJUSTING
SCREW.
A. Turn the ADJUSTING SCREW
counterclockwise towards " – "
to raise the POINTER TIP.
B.Turn the ADJUSTING SCREW
clockwise towards " + "
to lower the POINTER TIP.
Balance
Place the scale on a flat, firm surface. Turn the 6 LEVELING FEET until the bubble inside
the LEVEL is directly in the middle of the circle. Use LOCKING DIAL to lock LEVELING FEET
into place.
Level
Platform Top
Step1
Upper Weight Pointer Tip
Lower Weight
Step2
Adjusting Screw Detail
Adjusting Screw
Side
Locking
Dial
Leveling Feet
Leveling Foot
5