Configuring And Viewing Pim-Sm For Ipv6 Multicast Routing - Dell PowerConnect 8024 User Configuration Manual

Command
exit
exit
show ip pim
show ip pim interface vlan
vlan-id
show ip pim neighbor
vlan-id
[interface vlan
show ip pim rp-hash
groupaddr
show ip pim bsr-router
show ip pim rp mapping

Configuring and Viewing PIM-SM for IPv6 Multicast Routing

Beginning in Privileged EXEC mode, use the following commands to
configure PIM-SM for IPv6 multicast routing on the switch and on VLAN
routing interfaces and to view PIM-SM information.
Command
configure
ipv6 pim sparse
ipv6 pim spt-threshold
threshold
ipv6 pim register-threshold
threshold
Purpose
Exit to Global Config mode.
Exit to Privileged EXEC mode.
View system-wide PIM information.
View the PIM information for the specified interface.
View a summary or all the details of the multicast
| all] table.
View the RP router being selected for the specified
multicast group address from the set of active RP
routers. The RP router for the group is selected by
using a hash algorithm.
View the bootstrap router (BSR) information.
View group-to-RP mappings of which the router is
aware (either configured or learned from the BSR)
Purpose
Enter global configuration mode.
Enable PIM-SM as the multicast routing protocol on
the switch.
Set the Data Threshold rate, in Kbps (range: 0–2000)
for the last-hop (or leaf) router to switch to the
shortest path.
Set the rate, in Kbps (range: 0–2000), above which the
Rendezvous Point router will switch to a source-
specific shortest path tree.
Managing IPv4 and IPv6 Multicast
1197